View larger

Portland Earthborn Silicate Masonry Paint

Reference: E86013

Condition: New product

Earthborn Silicate Masonry Paint can be use on all mineral-based surfaces e.g. stone, masonry, concrete, pebble dash and plaster surfaces. It can be used both inside and outside the home.

More details

This product is no longer in stock

EARTHBORN PORTLAND SILICATE MASONRY PAINT

For a crisp, classic finish to external masonry, Earthborn Silicate Masonry Paint offers a high performance alternative to limewash.

Being water based and VOC free, it allows walls to breathe. Yet its special formulation with sodium silicate makes it very hardwearing. It is water repellent and can withstand severe extremes of weather.

Earthborn Silicate Masonry Paint does not yellow with time and can be washed down to keep it looking fresh.

High performance alternative to limewash.
Water repellent, weather resistant, does not yellow.
Helps prevent algae growth.
Water based.
VOC free.
Easy to apply with standard brush, roller or suitable spray gun.
Low acrylic content, highly breathable.
A water resistant, highly breathable matt masonry paint for use of Internal and External walls.

Earthborn White Silicate Masonry Paint is great for interior or exterior use, restoration work and historic buildings, new or old masonry, all mineral surfaces including brick, stone, concrete, pebble dash, plaster and render.

Product information:
Sizes:	10 Litre
Coverage:	5 – 7sq m/litre
Drying time:	Dependent on the temperature and humidity, touch dry after approximately 1 hour but allow 6-12 hours drying time between coats
Ingredients:	Water, sodium tetra-silicate, kaolin, calcium carbonate, styrene stabiliser, ammonium salt, titanium dioxide, common salt (sodium chloride
Preparation:	The surface must be clean, dry absorbent and dust and grease free. Take care to mask all adjacent glass, metal and ceramic before use. Gloss, lacquer, acrylic or oil-based paints are not suitable surfaces for Silicate Masonry Paint system, and must be removed.
Application:	Prime the surface with one coat of Ecopro Silicate Primer and allow to fully dry before applying Ecopro Silicate Masonry Paint. Important - do not use if the working temperature is below 8°C or expected to fall below 8°C within 24 hours of application. Stir the paint well before use and at regular intervals during use. Ecopro Silicate Masonry Paint can be applied with a brush, roller or spray gun. Apply thin, even coats. Keep a wet edge while painting and complete each wall/section in one go. Apply the second coat in the opposite direction to the first coat. Apply the first coat diluted with up to 20% Silicate Primer. Ensure each coat is dry before applying the next coat. Any paint splashes should be washed off immediately with plenty of water.

We are Lancashire Stockists of Earthborn Silicate Masonry Pain

Please see the colour chart and data sheet in the downloads for more information

If you either cannot see an Earthborn product you are looking for, or our catalogue shows any item as out of stock, do not despair!! As long as the item is available from the Earthborn manufactures we can provide the product for you.